Pristine Blue Pristine Power removes odors and organic materials, contaminants and body oils from your pool or hot tub. Pristine Power is contains no chlorine so it safe to re-enter the pool or hot tub in as little as 15 minutes. Product Dosage For Pools - Normal Bather Load: 1 pound per 10,000 gallons of water every 2 weeks. For Pools - Heavy Bather Load: 1 pound per 10,000 gallons of water every weeks. For Spas: 5 milliliters per 100 gallons of water after each spa use. Directions For Pools: Normal Bather Load: Apply 1 pound of Pristine Power per 10,000 gallons of pool water every 2 weeks. Heavy Bather Load: Apply 1 pound of Pristine Power per 10,000 gallons of pool water once per week. Application: Apply the required amount of Pristine Power shock treatment evenly throughout the pool with the pump and filter operating. Add the total amount at one time with a clean plastic spoon. Metal spoons will cause decomposition of Pristine Power. Application should be made with no swimmers in the pool. A waiting period of 15 minutes is recommended before reentering the pool. This allows time for the applied shock to disperse evenly. Note: Pristine Power is intended only for shock treatment of pool water. is not a disinfectant and does not replace the need for the regular application of a swimming pool sanitizer. For Spas: Apply at a rate of 5 milliliters or 1 teaspoon of Pristine Power per 100 gallons of water after each use of the spa or hot tub (not to exceed once per day) or once a week, whichever is more frequent. Ingredients Potassium Peroxymonosulfate: 36.4%, Other Ingredients: 63.6%
Pristine Blue Pristine Extra is used in the start up of the Pristine Blue chemical system. This chlorine shock dissipates rapidly, thus bringing your pool or spa back to a non-chlorine status quickly. Pristine Extra may also be used for troubleshooting pool and spa water. Product Dosage For Pools: 1 pound per 10,000 gallons of water at start up. For Spas: 5 milliliters (1 teaspoon) per 100 gallons of water at start up. Directions For spas or hot tubs, apply at a rate of 5 milliliter or 1 teaspoon of Pristine Extra per 100 gallons of water. For pools, apply at the rate of 1 pound of Pristine Extra per 10,000 gallons of of water in the deep end of the pool. To prevent damage to pool surface, use a pool brush to disperse any granules that may have settle to the bottom of your pool. Never allow undissolved product to rest in contact with bleachable surfaces. In water temperatures less than 70 degrees fahrenheit, or as an alternate application procedure, pre-dissolve the product prior to applying evenly to the deep end of the pool. Dissolve this product outdoors in a clean plastic bucket stirring with a clean plastic or wooden spoon. Add the product to water, never add water to product. Never add more than 1 pound or this product to 3 gallons of cool water. Do not mix with other product when pre-dissolving. ReEntry: Reentry into treated pools is prohibited above the levels of 3 ppm of chlorine due to risk of bodily harm. Ingredients Sodium Dichloro-s-Trizinetrione Hydrated: 99%, Other Ingredients: 1%, Available Chlorine: 55.5%